: openocd - try again > init > soft_reset_halt requesting target halt and executing a soft reset target halted in ARM state due to debug - request, current mode : Supervisor cpsr : 0x000000d3 pc : 0x00000000 MMU : disabled, D - Cache : disabled, I - Cache : disabled looks much better. : ok, it turns out that cu wasn't accepting my input for some reason (perhaps my serial config correct for 3-wire). *** Warning - bad CRC or NAND, using default environmentĪnd then it goes into a boot loop, because it can't find what it needs on nand NAND write: device 0 offset 0x0, size 0x80000 Write new image to nand Marvell> nand write.e 0x800000 0x0 0x80000 : to do - download rescue images and upload them via tftp (also in this article), or perhaps I could boot from a Linux usb plug and fix it all from there. : new u-boot - a 2017 version of u-boot is available, see this thread.
Seagate free agent dockstar how to#
Links: Dockstar debricking JTAG with BusPirate, with Wiggler JTAG, JTAG interface, How to restore a locked up Dockstar, Dockstar rescure tips, unbrick dockstar with buspirate, Debricking Segate Dockstar, Local linksĮK-LM4F120XL, FreeBSD ARM build, GoodFET42, Bus Pirate, LinksįreeBSD installation on the DockStar, FreeBSD wiki: Marvell, Update uBoot on your Dockstar, Install Debian Lenny on a Seagate Dockstar, Using Linux on a DockStar, OpenWrt Dockstar, Usb-to-serial cable: a TTL-232R-5V bought from Adafruit.
0 kommentar(er)
